1. Home
  2. LEA 2017
  3. Proceedings
  4. The Simulation of Cavitation Process Using the Engineering Analysis Methods

The Simulation of Cavitation Process Using the Engineering Analysis Methods

Roman Pidhirnyi1
Anna Hlukhaniuk1
Oleksandr Motrunich1 oleksandr.s.ivashchuk [at] lpnu.ua
Volodymyr Starchevskyy2 vstarch [at] lp.edu.ua
  1. Department of Chemical Engineering, Lviv Polytechnic National University, Ukraine, Lviv, S. Bandery street 12
  2. Department of General Chemistry, Lviv Polytechnic National University, Ukraine, Lviv, S. Bandery street 12
Abstract 

The expediency of analysis and evaluation of the cavitation process by methods on the CAE software complexes have been shown

Keywords 
CAE
engineering analysis
simulation
cavitation
SolidWorks
References 

[1] A. T. Ellis, “Cavitation in Hydrodynamics”, HMSO, Paper 8, 1956.

[2] S.S. Martynov, D.J. Mason, M.R. Heikal “Numerical simulation of cavitation flows based on their hydrodynamic similarity”, 2005.

[3] Q. Yang, Z Liu. et al. “Simultaneous Determination of Chemical Oxygen Demand (COD) and Biological Oxygen Demand (BOD5) in Wastewater by Near-Infrared Spectrometry”, Journal of Water Resource and Protection, Vol. 1 No. 4, 2009.

[4] L.I. Shevchuk et al. “Nyzkochastotni vibrorezonansni kavitatory”, p. 176, 2013.

[5] Tickoo Sham, “Solidworks 2016 for Designers”. CADCIMTechnologies, 2016.